␡
- 1-1 Introduction
- 1-2 Starting a New Drawing
- 1-3 SolidWorks Colors
- 1-4 Creating a Fully Defined Circle
- 1-5 Units
- 1-6 Rectangle
- 1-7 Moving Around the Drawing Screen
- 1-8 Orientation
- 1-9 Sample Problem SP1-1
- 1-10 Creating 3D Models
- 1-11 Saving a Document
- 1-12 Lines and Angles – Sample Problem SP1-2
- 1-13 Holes
- Chapter Projects
< Back
Page 14 of 14
This chapter is from the book
Chapter Projects
Project 1-1
Sketch the shapes shown in Figures P1-1 through P1-18. Create 3D models using the specified thickness values.

Figure P1.1 INCHES

Figure P1.2 INCHES

Figure P1.3 INCHES

Figure P1.4 INCHES

Figure P1.5 MILLIMETERS

Figure P1.6 MILLIMETERS

Figure P1.7 MILLIMETERS

Figure P1.8 MILLIMETERS

Figure P1.9 MILLIMETERS

Figure P1.10 INCHES

Figure P1.11 MILLIMETERS

Figure P1.12 MILLIMETERS

Figure P1.13 INCHES

Figure P1.14 MILLIMETERS

Figure P1.15 MILLIMETERS

Figure P1.16 INCHES

Figure P1.17 MILLIMETERS

Figure P1.18 MILLIMETERS
< Back
Page 14 of 14